The project is about developing an Arduino based AC motor control. In a previous project I have tried to use the Arduino to generate a PWM signal, that is later on filtered and amplified to generate a proper sine wave, that can be altered by frequency and amplitude to control a motor. Unfortunately with the current code it turned out, that the Arduino is not able to generate a stable sine, that will keep frequency and amplitude on a constant level over a longer amount of time - for several hours, but ideally as long as the Arduino is powered up. In a first step the given code shall be reviewed and optimized, to keep the PWM/sine signal stable. If necessary a new approach has to be found (based on the Arduino). The project will require availability of at least an oscilloscope, multimeter and an Arduino Uno board.
20 фрилансеров(-а) в среднем готовы выполнить эту работу за €179
Hi. I'm professional programmer/electronic hardware developer with experience over 20 years. I very well know Arduino platform and I can help you. Regards, Alex.
I have just done such project and I am familiar for arduino motor. I have a development board, so that I can finish ASAP. I am all ready for hardware and software.
I have experience in programming Arduino and knowledge in logical programming and also circuits design and simulations. Please message me to discuss further. I have Arduino hardware with me now. Thank you.
I am an electronics engineer. I am experienced on Arduino and AC motors. I have the required devices oscilloscope, multimeter and an Arduino Uno board in my laboratory.