Hello, I have a DA 8620 driver connected to a small OLED display. The driver is connected to a PCB expansion board so each pin on the display is expressed to 39 through hole pins that can be easily soldered (see attached image). The display, however, still requires power and data as seen in the technical document PDFs below. Ideally, I'd want someone to design and implement a solution for connecting this display to a device so that it can be used as if it were a normal display. Something like an Arduino or Raspberry Pi would be perfect. I already have several step up and buck converters that I can use. Let's aim for a solution that is functional, compact, and cheap.