Thanks very much for taking the time to look at this job.
The board is a breakout board for an arduino nano with some input and output devices listed bellow. I will provide a detailed list of connectors and eagle libs you can use for all the parts.
No programming is required, only hardware.
All work to be done in Eagle (that way I can help with changes if needed)
Make a carrier board for 5v ATmega328P Arduino
2 x Input connectors for water float switches
1 x input for DS18B20 temp sensor
1x output connector for 12v DC pump 1 amp (MOSFET switched)
2x outputs for 4 pin fans (PWM Controlled)
5 x LED output (Using Meanwell constant current driver, I will supply eagle lib)
5v ATmega328P Arduino (attached to board using 0.1" 15-pin female header)
LM Vregs to drop voltage
I understand electronics and have made PCBs before and can help with questions you may have during the design process.
I look forward to working with you.
10 фрилансеров(-а) готовы выполнить эту работу в среднем за $98
I have read and fully understood your requirements. Please open chat to discuss further….. =================+++++++++++++++++++++++++======================