Need an implementation of a TDC on the Artix-7 for a LIDAR application. Should work on Digilent Cmod-7 Board for hardware testing. Higher pay for higher resolution.
rst (active low)
startstop (after reset, first rising edge is start signal, second rising edge is stop signal)
data ready (active high)
Should reset every time a reading is needed, and read the data upon data ready. Should be validatable with crystal testbench
13 фрилансеров(-а) в среднем готовы выполнить эту работу за $527
Dear sir I have more than 10 years experience in digital design using FPGA, also i have done many projects using ARTIX7 FPGA, please message me so that we can discuss more details best regards
I have just done such project and I am familiar for zynq7020 board that have artix-7. I have a development board, so that I can finish ASAP. I am all ready for hardware and software.
I DO NOT OUTSOURCE I have been a freelancer for the past 8 years, I believe that my experience and skill in this background will prove to be of great help to you. Contact me to discuss more on the details
Hi there, I have checked the details. I have rich experience with Electrical Engineering, Electronics, FPGA, Microcontroller, Verilog / VHDL. Please initiate the chat so we can discuss this job in detail.