I would like to get a PCB designed to interface a caliper with arduino.
Basically the idea is to have a PCB where is possible to solder a sparkfun ardiuno promini and some additional components (transistors, resistors).
All the system will be installed inside a plastic box and micro USB should be accessible from outside.
Check attached scheme.
HI, I am kahan. I am embedded engineer and i have much experienced in hardware and software side. I can make the pcb as per given file, and give it in time. Waiting for further discussion. Thank you
55 фрилансеров(-а) в среднем готовы выполнить эту работу за €21
Hello. I'm a hardware engineer and PCB designer. You may check my qualification in profile We can discuss any question, I believe we can have a good cooperation