The pcb design that i made has an small error and i need someone to help me figure out the issue.
Its a combination of Arduino Nano MCP328P + MCP2515 CANBUS board but in a smaller size with lots of extra arduino nano stuff removed as i will not be needing it.
MCP328P chip and FDTI chip do communicate with PC and all digital/analog in/outs work quite well so no issues there, however the MCP2515 part is not able to receive nor send CANBUS messages so i am guessing within this simple pcb design i made an error that i cannot figure what is.
17 фрилансеров(-а) готовы выполнить эту работу в среднем за $33
Hello! I can check out your design and i'm going to solve it. I don't like the route, but it's another thing. Could you send to me the Altium project? Best regards,
I have an experience of working on PCB development and CANBUS(Extended and normal frames) for more than 4 years. I can solve the issue very quickly given a chance.
I have 10 years of experience in electronics engineering. I you could sent me the project I could have a look into it and tell you what the problem is.