MICROCONTROLLER APPLICATIONS
Бюджет $250-750 USD
Job Description:
Set up the frequency of the HCLK clock to 96MHz and the frequency of the
PCLK1 peripheral clock to 24MHz, respectively, using the HSI (16MHz) clock
source. Program the microcontroller such that you will be able verify the HSI clock
and the PLL clock, respectively, on pin MCO1 (PA8).
Part ii
Set up the frequency of the HCLK clock to 120MHz and the frequency of the
PCLK1 peripheral clock to 30MHz, respectively, using the HSE (8MHz) clock
source. Program the microcontroller such that you will be able verify the HSE clock
and the PLL clock on pin MCO2 (PC9).
Task Two
Port D (PD7…PD0) is designated as output port for this task.
1. Draw a detailed schematic diagram for Task Two. It should include IC part
numbers, IC pin numbers and Header P1 pin labels, respectively. All signal
lines should be labeled. Port D signals should be buffered by a suitable chip to
drive the bar-LED bits (and for protection). Current limiting pull up resistors
for the LED module should also be employed.
Develop a C program that will set up the lower segment of Port D for output.
The program will then write alternating data (e.g., 0x5A, and 0xA5) on the
port while running in an infinite loop.
16 фрилансеров(-а) готовы выполнить эту работу в среднем за $500
Hi! I have understood your requirements about your project with every detail of it. I am an Electrical Engineer with more than 7 years of experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embedded Больше
We are a team of Electrical and Electronics engineers, we have successfully completed 1000+ Projects for multiple regular clients from OMAN, UK, USA, Australia, Canada, France, Germany, Lebanon and many other countries Больше
Hello Sir I have an Honors degree in Electronic Engineering and I have over 6 years experience developing embedded applications and PCBs. I also have C and C++ Certifications here on Freelancer and you can learn more Больше
⭐⭐⭐⭐⭐I am senior Firmware & PCB Design,Java, C#,and C++ Developer ⭐⭐⭐⭐⭐ Hello I am Inigo H. I've seriously read your post and I have understood what you need. I am sure that I can be the best developer who can per Больше
Hi, I am a professional mechatronics engineer and Microcontroller expert .I'm here to help you with your project. I have more than 3 years working experience in this field. I am confident that I can deliver you best q Больше
Hello there. Nice to meet you. I think I am the candidate developer that you find. I am good at PCB design and embedded firmware programming too. So can help you. Hope to more discuss this with you.
HI. Thank you for your posting job. I have good experience with embedded programming and harware , electric circuit design. So please contact me and discuss more details. Hope u choose me, and give me chance for show m Больше
I have done progrming of 32Bit TI DSP soit will be very easy for me to do these both task once i have clarification on which controller you are expecting to use.
Hello bharadwajakash90, I m an Architect/Civil Engineer/BIM/CAD Expert and will offer you the Best Discount. You can pay me a reasonable price + Good Review only. I want to review your MICROCONTROLLER APPLICATIONS pl Больше
Hello I can do this. Please share the details of the task so that I can check and confirm accordingly.
I can program the microcontroller to set up the frequency of the HCLK clock to 96MHz and PCLK1 peripheral clock to 24MHz using the HSI clock source, and verify it on pin MCO1. I will use the following steps in programm Больше
