I would like to have two things designed that are based on the paper that you will find attached.
1) A "needle" array in a hexagonal pattern as described in the paper. The difference to the paper would be that the needles need to be a standard, gold coated, round contact pin of appropriate length. Ideally a cheap part available in large quantities. The needle array must be divided into 3 electrical subsets as described. The array must fit into one well of a multi-well cell culture plate. The dimensions are shown in the attached file.
The array will be used in exactly the same manner as in the paper, to electroporate cells. The PCB would sit on top of the well of the plate and the gold pins sticking down into the liquid. The pins will need to get within 0.5 to 1 mm of the well bottom.
2) The electroporator will produce square wave pulses of up to 1000 V. The paper vaguely describes a circuit sitting between the +/- output of the electroporator and the needle array with 3 sets of pins to switch polarity from 1/2 to 1/3 to 2/3 and so forth.
The needle array would be a disposable part that is used once and discarded. Production/population/soldering must be automatable.
19 фрилансеров(-а) готовы выполнить эту работу в среднем за $673
Hi, I have almost 15 years of experience. I have read the details and have a few questions. Please get back to me to discuss it further. Waiting for your response Thanks
I'm an Embedded software engineer , i have experience in embedded systems and C programming. I'm interested in your project. let us talk about your project and requirements.